This specification covers pvc pipe in schedule 40 80 and 120 for pressure applications.
Sch 40 pvc pipe fitting dimensions.
Pvc pipe fittings are used for attaching pvc pipes together.
Schedule 40 and schedule 80 pvc pipe and fittings have identical od outer diameters and can be used interchangeably if needed.
It is only the inner diameter measurement that is smaller on schedule 80 pvc thus making for a.
Pvc schedule 40 fittings accessories technical information pvc schedule 40 fittings dimensions information injection molded dimension references.
H intersection of center lines to face of fitting.
90 elbows tees crosses.
This system is intended for pressure applications where the operating temperature will not exceed 140 f.
Pvc schedule 40 pipe fittings.
Schedule 80 pvc pipe has thicker walls than schedule 40 but still has the same od.
G laying length intersection of center lines to bottom of socket thread.
Regardless of schedule a 1 pvc pipe will fit into.
Information on the physical properties of pvc polyvinyl chloride relating to maximum service temperature tensile strength and more.
A 2 pvc fitting on our site will always fit a piece of 2 nominal size pvc pipe.
Schedule 40 pvc fittings dimensions spears schedule 40 pvc physical properties.
6 schedule 80 fittings tee s x s x s pvc part no.
Fortunately there are many different types of pvc pipe fittings so that you can run pipe in pretty much any configuration.
Be aware that schedule 40 pvc pipe does have a lower pressure rating therefore using schedule 40 parts on.
Both schedule 40 and schedule 80 pvc fittings will fit onto pvc pipe of either schedule.
While id of pipe may vary by schedule the id of fittings is always the same as the od of the pipe it is meant to work with.
8400 s socket spg spigot mpt male pipe thread fpt female pipe thread all dimensions are in inches.
Schedule 40 pvc pipe dimensions white pvc fittings.
That s because both types of pipe have the same outer diameter measurements.
Pvc pipe sizes are different than the size the pipe is called.
Below is our extensive pvc pipe fittings guide with a series of diagrams and dimension charts.
For correct pipe and fittings connections always use pipe and fittings with the same nominal pipe size.
Fittings follow this same pattern a 1 fitting has a 1 315 inch opening to accept a 1 inch pipe which actually measures 1 315 inches in diameter.
For example a 1 inch pvc pipe is actually 1 315 inches in outside diameter and 1 029 inches in inside diameter.
3 way pvc corner fitting.
